Version 06.09.2018
HW (V32)/CY10(V41)
CI-RL5-UCON8-CP
P
a
g
e
5
2.
Installation
Switch off ignition and disconnect the vehicle’s battery! The interface needs a permanent
12V source. If according to factory rules disconnecting the battery is to be avoided, it is
usually sufficient to put the vehicle to “Sleep-Mode”. In case it does not succeed,
disconnect the battery with a resistor lead.
If power source is not taken directly from the battery, the connection has to be checked
for being start-up proven and permanent.
2.1.
Place of installation
The daughter PCB shell be installed and connected inside the factory Monitor housing.
