R.E. Williams Contractor Inc. www.rewci.com
Страница 1: ...nto the wall do not damage electrical wiring and other hidden utilities 12 The unit has been tested to be in contact with insulation Type IC 13 The heater must be properly grounded 14 For supply connections use No 14 AWG or larger wires suitable for at least 90 c 194 F 15 For overheat protection exhausting automatically turns on when temperature above the ceiling exceeds 90 C 1941 16 The lamps are...
Страница 2: ...ing Figure 3 moun ng bracket Figure 3 2 Fix the brackets Figure 2 housi a Position housing between joists and extend mounting brackets Position brackets so that bottom edge of housing will be flush with suspended ceiling Mark the top of keyhole on all four mounting brackets Figure4 b Remove housing temporarily and pound nails partially into joists at all four marked locations Figure5 c Hang housin...
Страница 3: ...mps remove the wire cover unwire out plug then take out 6 screws from clapboard Remove clapboard for clean and maintenance Note Electric parts are prohibited from touching water 4 Install all the parts in reverse after they become dry thoroughly 2 Lamp Replacement 1 Check and tighten globes regularly 2 Shut off power before replacement 3 Use a 120V maximum 60W type A bulb only for lighting 4 Use o...
