R. Beck Maschinenbau 191.100.00, Руководство по эксплуатации

Страница: 24 / 42

24
BA_BM_HS-300-LARGE_EN_45-21.docx
11.2.2.1 Swivelling Universal Clamping Plate
Figure 18: Swivel clamping plate
In contrast to the universal clamping plate that can be fixed flat on the table,
the swivelling version (art. no. 200.406.00) can be tilted by up to 90°.
•
Simply loosen the clamping wheel ( H ) by turning it to the left, set the de-
sired inclination and tighten the clamping wheel again.
11.3 Unclamp Workpiece
Caution: Danger of crushing feet and toes when unclamping the workpiece (especially with
large plates)! Wear safety shoes with steel toecaps and secure LARGE panels against falling
and tipping by means of the fold-out support brackets before loosening.
Important: In order to prevent chips, dust and dirt from getting into the vacuum circuit and thus into the
pump, the following measures must be carried out after workpiece machining:
•
After machining or before unclamping the workpiece, thoroughly remove chips, dust and dirt from the vac-
uum clamping device under operating vacuum (e.g. with an industrial hoover).
•
Only then switch off the vacuum by means of the foot switch and remove the workpiece.

The penetration of chips, dust and dirt can damage the vacuum pump! Place the vacuum pump
in a clean dry place and make sure, that the exhaust holes on the pump housing are kept clear
at all times.
Figure 19: Foot switch for unclamping the workpiece Figure 20: Remove workpiece
Instructions for possible troubleshooting of the vacuum clamping unit can be found in chapter

12. Article
numbers and other accessories for the vacuum clamping device are listed in section

17.6.
11.3.1 Technical Specifications of the Vacuum Pump
Suction power 3,0 m
3
/h (optional 4,6 m
3
/h) Housing Mobile carry box
Foot switch connection Fabric hose Vacuum reservoir Tank
Power connection 230 VAC / 50 Hz Shut-off when tank is full automatically
Connection cable Earthed plug (5.0 m) Connection coupling sockets 2 pieces
Weight approx. 20 kg Ambient temperature 0 - 40° C
H