1.
Make sure the wiring is safely inside the
outlet box as instructed in Step 5 - Electrical
Connections. To install the canopy, remove
the 1 of 2 screws from the bottom of the
mounting bracket and loosening the other
one a half turn from the screw head. Slide
the canopy up to mounting bracket and
place the key hole on the canopy over the
screw on the mounting bracket, turn canopy
until it locks in place at the narrow section
of the key holes. Secure tightening the two
set screws. (Fig. 9)
2.
Blade Assembly & Installation (Fig. 10)
Using the supplied blade arm screws, attach
the blades to the blade arms. In some cases
the fiber washer is permanently fixed to the
screw head. Ensure all screws are used for
each blade. Next attach the blades to the
motor assembly using the supplied screws.
DO NOT bend the blade arms when
installing the blades.
3.
Attaching the Control Cup
Snap together the cannon plugs, attach the
control cup to the control cup plate with the
three screws provided. (Fig. 11)
A certain amount of wobble may be
considered normal, especially if the fan is
on a downrod long than 12".
6. COMPLETING
THE
INSTALLATION
Fig. 10
Fig. 11
Fig. 9
Outlet box
Hanger
bracket
Canopy
Screws
Screws
Screws
Fiber
washers
Screws
Blades
Blade arms
Screws
Control
cup
Cannon plug
Control cup plate