8
2.1 Installing paper rolls
Cut the edge
Do not try to feed
to be fed straight
the paper if it is
like this
like this
this way
not this way
cut the paper here
2.2 Installing and replacing the ribbon cassette
1. Lift up and remove the printer
cover.
2. Load the paper rolls into their
respective receptacles. The end of
the paper roll must feed from
below.
3. Feed the end of the paper roll into
the paper entrance of the printer.
Press and hold the “Journal Feed“
key and feed enough paper so it
can be inserted into the slot of the
take-up reel. Wind two or three
turns of paper around the reel.
4. Now feed the end of the receipt
paper roll into the printer. Press
and hold the “Receipt Feed“ key to
pass the paper through the printer.
5. Feed the paper from below
through the paper slot of the
printer cover and reinstall the
printer cover.
To remove a paper roll, cut as shown
and feed out the cut-off paper with the
respective “PAPER FEED“ key.
1. Lift up and remove the printer cover.
2. Fit the left side clip of the ribbon
cassette into its receptacle of the
cassette holder and press down on the
cassette for a proper fit. To remove a
used ribbon cassette push it to the left
and lift it out.
3.
Reinstall the printer cover.
