Drilling hole
• Note: The tap hole for the Nordic single tap should be 32 mm in diameter.
The Fusion, Nordic mixer tap and Flex tap hole should be 35 mm in diameter.
• The Nordic single tap should ideally be positioned at the corner of the sink
to enable use above the sink or the work top.
• Note: It must be possible to move the spout of the Nordic single tap freely up
and down. When the spout is in its lowest position it projects ca. 25 cm below
the work top. Bear this in mind when fitting the inlet combination valve,
sockets and the like.
• Note: The Flex tap coupling must be able to move freely. When the hose is not
withdrawn it hangs approximately 40 cm below the work surface. Make allowances
for this when fitting the inlet combination valve, power sockets and so forth.
A
1 Select position
Nordic single tap
Select a suitable position for the
Nordic single tap based on the type
of sink and position of the mixer tap.
2 Drilling hole for
Nordic single tap
Using the correct drill bit, drill a hole
of 32 mm through the work top for
the Nordic single tap.
In the case of a hole of 35 mm or
larger, use the black plastic centring
ring provided to secure the tap in the
larger hole.
Note: For the Nordic mixer tap please
refer to the separate guide.
3 Drilling hole for
Fusion or Flex tap
Select a suitable position for the
Fusion or Flex tap. Using the correct
drill bit, drill a hole of 35 mm through
the work top.
Nor
dic single tap
Q
M
Mixer tap
1
2
3
Dimensions in mm
Dimensions in mm
Dimensions in mm
60
Installatieinstr VAQ E UK 30.225.03.V15 11-12-18 09:32 Pagina 11
