2of2
2016 QuoizelInc.
RevisedDate:2016-11-10
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
or visit us on-line at www.quoizel.com
STEP 4
-
Test Fit the Backplate to the Crossbar Assembly
A. Place the backplate and Fixture Body (B) onto the Mounting
Screws (DD) or Alternate Short Mounting Screws (FF) and secure
with Mounting Balls (EE). Note: The backplate and Fixture Body (B)
should be snug against the wall and held tight with the Mounting
Balls (EE). If it is not, adjust the length of the Mounting Screws
(DD) or Alternate Short Mounting Screws (FF) on the Crossbar by
unscrewing the Hex Nuts (CC) and Lock Washers (BB) and then
screwing the Mounting
Screws (DD) or Alternate
Short Mounting Screws (FF)
in or out of the Crossbar
(AA) until the correct length
is achieved. Once the
backplate and Fixture Body
(B) is secure, remove the
Mounting Balls (EE) and
Fixture Body (B) and
proceed to Step 5.
9”
7”
18”
B
Backplate
Hex Nut and
Lock Washer
Figure 4
Mounting Screw
or Alternate Short
Mounting Screw
EE
AA
STEP 5
-
Attach the Lanyard
A. The purpose of the lanyard is
to provide a means to support
the fixture hands free from the
junction box while connecting
the electrical wires.
B. Turn the Button Stop so it may
be inserted into a Crossbar
slot. Make sure the Button
Stop is completely inside the
Crossbar. Slowly release the
fixture to make sure it is
supported by the Button Stop.
Proceed to the wiring steps in
the next step. Once you are
complete with the wiring, the
Lanyard will push into the
junction box when the fixture is
placed for final mounting.
Figure 5
Crossbar
Button
Stop
Lanyard
Slot
B
STEP 6 - Wire Connections
A. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Figure 6
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from fixture
Bare, or Green
Ground wire
from outlet box
OR
Ground wire
from fixture
Green Ground Screw
on the Crossbar
STEP 7
Install the Fixture
Body
-
A. Position the backplate and
Fixture Body (B) onto the
. Secure the
by using the Mounting
Balls (EE) and hand tighten
the
until snug.
Mounting Screws (DD) or
Alternate Short Mounting
Screws (FF)
backplate and Fixture Body
(B)
Mounting Balls (EE)
Figure 7
B
Backplate
Mounting Screw
or Alternate Short
Mounting Screw
EE
AA
STEP 8
-
Install the Bulb
A. Insert the supplied Bulb (A) onto
socket and push snugly into place.
B. Place the glass panel back onto the
Fixture Body (B) and secure with
lock screws with rubber washers.
Your fixture is now assembled and
ready to use. Enjoy!
B
A
Figure 8
Glass Panel
Lock Screw with
Rubber Washer
ZP8418MD
FINISH: MUTED BRONZE
NOTE: ALL DIMENSIONS ARE ROUNDED UP
TO THE NEAREST 1/4
"