1of2
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
,
.
.
.
Assembly Instruction Sheet #IS-ZP8418MD
_R1
For Style ZP8418MD
Please go to
for product cleaning tips. Go to the
selection.
(1) T4 Mini Candelabra Bulb 50W Maximum (supplied).
30-45 minutes
Identify and inspect all parts before beginning installation. Check package content list and diagrams below to be sure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer service for replacement
parts.
www.quoizel.com
Care + Maintenance
Light Source:
Estimated Assembly Time:
Preparation:
Tools Required:
Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
A
Fixture Body
x 1
B
Package Contents
Hardware Contents
AA
BB
CC
Crossbar
x 1
Lock Washer
x 2
Hex Nut
x 2
DD
Mounting Screw
x 2
EE
Mounting Ball
x 2
Figure 2
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
or visit us on-line at www.quoizel.com
FF
Alternate
Mounting screw
x 2
2016 QuoizelInc.
RevisedDate:2016-11-10
T4 Mini Bulb
x 1
Glass Panel
Lock Screw with Rubber Washer
STEP 1
Remove Glass Panel from Fixture Body
-
A. Locate the Fixture Body (B) onto a flat work surface. Loose Lock
Screws with Rubber Washers and then remove them and Glass
Panel from the Fixture Body (B).
B
Figure 1
STEP 2
-
Attach Mounting Screws, Lock Washers and Hex Nuts to
Crossbar
A. Line up a set of holes on the Crossbar (AA) and Holes on the
Backplate of Fixture Body (B). Thread Mounting Screws (DD) or
Alternate Short Mounting Screws (FF) into the holes on the
Crossbar (AA). Pass Lock Washers (BB) and thread Hex Nuts (CC)
onto the Mounting Screws (DD) or Alternate Short Mounting Screws
(FF). Hand tighten until snug.
Note: Use the Alternate Shorter Mounting Screw (FF) if your
installation requires a shorter mounting screw.
AA
AA
Mounting Screw
or Alternate Short
Mounting Screw
BB
CC
B
AA
Mounting Screw
or Alternate Short
Mounting Screw
Backplate
STEP 3
-
Installing the Crossbar Assembly
A. Pass the supply wires through the Crossbar (AA). Attach the
Crossbar (AA) to the Outlet Box with the head of the Green Ground
Screw facing you. Secure the Crossbar Assembly (AA) with Outlet
Box Screws (not included). Tighten until snug
.
Outlet Box
Outlet Box Screws
(not included)
AA
Supply Wires
with Ground Wire
Figure 3