3
UNPACK
QUILLA™
Carefully unpack Quilla
™
and all loose items from package. Before installing Quilla
, verify that you’ve
received the following:
eWriter:
Quilla
Writing device:
Pen, 2pcs.
Power supply:
Meanwell GST90A19-P1M
Battery:
Installed, RRC2040-2
Cords and Cables:
Power Supply, Ferrite Core
Mount:
QuirkLogic Lift & Go Wall Mount, 2 Wall-Spacers
Screws & Wall Anchors:
(13) #8 screws, (13) Anchors and (13) Washers all included
Tools Required
Screwdriver /
4’
Level / Tape Measure /
Pencil
CAUTION!
Do not connect Quilla to the power source until Quilla is completely assembled and installed on a
wall-mount. Read and understand the entire Installation & Safety Guide.
ON THE WALL & OFF AND RUNNING
INSTALLING QUILLA ON THE CUSTOM WALL-MOUNT
1.
Properly choose and prepare the install location for Quilla. Consider access, power, Ethernet access,
ventilation and visibility when choosing your location.
2.
Determine the desired height for Quilla.
A recommended height is approx. 80”
from the floor to the top
of Quilla. The top of the wall mount will sit flush with the top of the device.
3.
Disassemble the wall-mount by removing its cover. To remove the cover, gently press the tabs on the
bottom of the unit and lift off the top.
(See Figure 1)
4.
Using a tape measure, measure a
horizo
ntal line (29” long) at the 80”
height level. Mark the center of this line and then
make a mark (1 3/8” down from the line). Drive an
anchor into the wall in this location for the wall mount center location.
Figure 1
–
Quick Release Tabs
