![background image](http://html1.mh-extra.com/html/quiques-aircraft/yak-54s/yak-54s_assembly-manual_3755154037.webp)
Section 13-Canopy Installation
Required Tools and Adhesive
•
Xacto knife, #11 blade
•
Drill
•
Thin/Medium
C/A
•
5-minute
epoxy
Step 1
First glue the two small carbon fiber
tubes in the front of the canopy.
Figure 60
Step 2
Now install the two blind nuts on the
inside of the tabs that are on the
bottom and rear of the canopy. Use
a canopy attachment screw with a
flat washer with a 2.5 mm Allen
wrench and tighten the blind nuts
firmly into the tabs. Run some thin
C/A around the blind nuts to ensure
they won’t vibrate out.
Note: You can change all the metric
blind nuts and screws that come with
your kit with standard blind nuts and
screws. In that case use 4-40 screws
and blind nuts.
Step 3
Now open up the two canopy access
holes on the side of the fuse with a
no. 11 Xacto blade.
Step 4
There is a brass metal tube installed
in the fuse sides that extends to the
film covering on the side of the fuse.
Trim the film covering around the
inside of the brass tube.
Step 5
Trim the film covering around the
inside of the brass tube.
Note:
In case your fuse doesn’t have the
brass tubing then see Step 9.
Step 7
There are two small rubber O-rings
provided.
Very Important:
For the
canopy attachment to work properly,
you must insert each small O-ring all
the way inside the brass tube until
the O-ring bottoms out against the
plywood. If you don’t insert the O-
rings, you will not be able to remove
the canopy hatch and that will be a
serious problem.
Step 8
To insert the O-rings, make a piece
of 3/16 wooden dowel about 2
inches long. Place the O-ring just
inside the brass tube at the side of
37
Содержание Yak-54S
