QuiQue's Aircraft Semi Scale Yak-54, Инструкция по сборке

Страница: 9 / 46

Section 2-Horizontal Stab And Elevator Installation
Required Tools and Adhesive
•
Ultra fine point Sharpie
•
Acetone
•
Xacto knife, #11 Blade
•
Felt tip marker
•
Thin and thick C/A
Step 1
Center the H. Stab so that the left tip
and right tip are equal distance from
the fuselage sides. See Figure 4.
Figure 4
Step 2
Square up the H. Stab by measuring
the diagonal distance from the turtle
deck to the back corners (left and
right) of the H. Stab. They must be
the same distance. See Figure 5.
Depicted picture is not for this plane, however it’s
showing you how to ensure stab is perfectly
centered and lined up
Figure 5
Step 3
Mark lines on both sides of the H.
Stab top and bottom with a fine felt
tip black marker, an Ultra Fine Point
Sharpie ® works well in this
application. Later when you are
ready to remove the black lines,
acetone works best.
Figure 6
Step 4
Remove the H. Stab from the fuse.
Mark a line, measured 1 mm on the
inside of the two lines top and
9