Section 15-Radio Equipment
You are now in the final stages in
completing the assembly of your
Yak-54. Mount the receiver using
following method:
1.
Cover the bottom of the receiver
completely with wide masking
tape.
2.
Apply some beads of medium
C/A.
3.
Attach a piece of foam the size of
the bottom of the receiver to the
bottom of the receiver.
4.
Attach sticky back Velcro to the
foam. To ensure that you have a
good bond, apply some CA to the
foam, then stick the Velcro to it.
5.
Stick opposite side Velcro to the
tray and mount the receiver on
top of it.
The receiver floats gently but is not
fixed too firmly. If a receiver is
fastened too tight in the airplane
there could be problems with engine
vibration transmitted to the receiver.
Figure 97
Figure 98
Figure 99
Figure 100
39
Содержание Semi Scale Yak-54
Страница 34: ...Figure 82 Figure 83 34 ...
