Lead Check
1. Select the Menu by pressing the
Up/Right button continuously
for several seconds. “Lead Check” will appear.
2. From the Menu, select
Lead Check by pressing the Enter key.
3. A graph depicting the impedance measured at the Right Arm
(RA), Left Arm (LA), Left Leg (LL) and optional V leads is displayed
from left to right in vertical columns on the screen. The higher the
bar, the better the contact is between the skin and the electrode.
4. A full-bar graph means optimal high quality and good electrode
contact. For good quality transmissions, the bars should reach or
exceed the horizontal line on the display. A low-bar graph means
poor quality and high electrode impedance. The skin preparation
should be checked for improvement and, if necessary, the
electrode(s) should be replaced.
5. Once acceptable impedance levels are ver ed, press any of the
three keys to return to the Lead Check menu.
6. Press the
Down key to scroll to Done. Press the Enter key.
Lead Failure
A lead failure is displayed as a lead designator on the LCD display. If
the patient cable is not attached, the LCD will display all leads as
disconnected.
Battery Voltage Indicator
The X12+ is powered with a single AA alkaline battery that requires a
minimum of 1.0 volts to operate. When the battery contains su cient
voltage, the main menu displays an image of a battery in the upper
right corner showing the current battery voltage in increments of
100%, 75%, 50%, and 25%. If a battery with unknown voltage is
inserted and the LCD menu does not appear, insert a new battery.
When the battery indicator shows a voltage of 25%, discard the
battery and insert a new battery into the battery compartment.
REF: 70-00256-01 Rev C1
Attaching Patient Cable
The Patient Cable consists of a connector block, main cable and four
ve leadwires connected to the main cable. Each leadwire
terminates in a snap connector. The leadwires are positioned on the
main cable to follow the contour of the torso.
Insert the connector block into the input connector on the side of the
transmitter, making sure that it is parallel to the transmitter input
connector.
Reorder Information (www.mortara.com)
Part No.
Description
000310-001
Quik-Trace multipurpose electrodes (30/pouch)
036817-013
Transmitter lead set, 4-wire, AHA
036817-014
Transmitter lead set, 4-wire, IEC
036817-003
Transmitter lead set, 5-wire, AHA
036817-004
Transmitter lead set, 5-wire, IEC
042174-001
Pouch and belt for X12+ Transmitter
Mortara Instrument, Inc.
7865 North 86th Street, Milwaukee, WI 53224 U.S.A.
Tel: 1.800.231.7437 • Fax: 1.414.354.4760
Website: www.mortara.com
Technical Support:
Tel: 1.888.667.8272
Email: [email protected]
Copyright©2014 Mortara Instrument, Inc. All Rights Reserved.