Quincy QSV 2200, Инструкция по эксплуатации

Страница: 10 / 124

Section I - Safety precautions
10 Quincy Vacuum Pump-QSV Series
8. Periodically check that:

All guards are in place and securely fastened

All hoses and/or pipes inside the machine are in good condition, secure and not rubbing

There are no leaks

All fasteners are tight

All electrical leads are secure and in good order

Safety valves and other pressure relief devices are not obstructed by dirt or paint

Air outlet valve and air net, i.e. pipes, couplings, manifolds, valves, hoses, etc. are in good repair,
free of wear or abuse

Electrical cabinet air cooling filters are not clogged
9. If warm cooling air from vacuum pumps is used in air heating systems, e.g. to warm up a workroom,
take precautions against air pollution and possible contamination of the breathing air.
10. Do not remove any of, or tamper with, the sound-damping material.
11. Never remove or tamper with the safety devices, guards or insulations fitted on the machine.
12. The oil separator tank can be slightly pressurised. Do not open and do not leave oil filler or drain plugs
open during operation.
13. Do not use the pump as a compressor.
14. Never run the pump without the air intake filter mounted.
15. On water-cooled vacuum pumps using open circuit cooling towers, protective measures must be taken
to avoid the growth of harmful bacteria such as Legionella pneumophila bacteria.
NOTICE!
Also consult sections Safety precautions during installation and Safety precautions during
maintenance or repair. These precautions apply to machinery processing or consuming air or inert
gas. Processing of any other gas requires additional safety precautions typical to the application
which are not included herein.
Some precautions are general and cover several machine types and equipment; hence some
statements may not apply to your machine.
1.5 Safety precautions during maintenance or repair
CAUTION!
All responsibility for any damage or injury resulting from neglecting these precautions, or non
observance of the normal caution and care required for installation, operation, maintenance and
repair, even if not expressly stated, will be disclaimed by the manufacturer.
Precautions during maintenance or repair
1. Always use the correct safety equipment (such as safety glasses, gloves, safety shoes, etc.).
2. Use only the correct tools for maintenance and repair work.
3. Use only genuine spare parts.
4. All maintenance work shall only be undertaken when the machine has cooled down.
5. A warning sign bearing a legend such as "Work in progress; do not start" shall be attached to the
starting equipment.
6. Persons switching on remotely controlled machines shall take adequate precautions to ensure that
there is no one checking or working on the machine. To this end, a suitable notice shall be affixed to
the remote start equipment.
7. Before removing any component, effectively isolate the machine from all sources of under- and/or