Quietside DPW-099, Руководство пользователя

Страница: 65 / 80

65
Specific requirements for installation in Massachusetts
In the Commonwealth of Massachusetts these units must be installed by a
licensed gas fitter or plumber
Venting :
For the Quietside models DPW-099A, DPW-120A where the bottom of the vent
termination and combustion air intake is installed at a height
BELOW 4 ft above
the grade level the following requirements must be satisfied
1. If there is not one presently installed, on each floor level where there is a
bedroom(s), a Carbon Monoxide detector and alarm shall be installed in
the living area outside the bedroom(s). The Carbon Monoxide detector
shall comply with NFPA 720 (2005 Edition)
2. A Carbon Monoxide detector shall be installed in the room where the
ODW unit is installed, the detector shall be :
a) Powered from the same power circuit that provides power for the ODW
unit. A single electrical service switch shall be used to service both the
unit and the detector
b) Have battery back up power
c) Meet ANSI/UL std 2034 and comply with NFPA 720 (2005 Edition)
d) Approved and listed by a NRTL recognized under 527 CMR
3. A Quietside approved vent termination must be used. Installation of the
vent terminal must be in strict compliance with Quietside’s written
instructions, and a copy of these instructions must remain with the unit
after the installation is completed.
4. A metal or plastic identification plate shall be mounted on the exterior of
the building, 4ft above the vent termination. The plate shall read “ Gas
Vent Directly Below ” with text size visible from a minimum of 8ft.