QuickJack BL-3500SLX, Руководство по установке и эксплуатации

Страница: 48 / 72

QuickJack™ Portable Car Jack
48
P/N 5900959 — Rev. L1 — December 2020
Maintenance
Refer to ANSI/ALI ALIS Standard (R2015)
Safety Requirements for Installation and Service of
Automotive Lifts for more information about safely servicing your QuickJack.
⚠
WARNING:
Remove power from your QuickJack before performing any maintenance! The
QuickJack must be de-energized and you must take steps to make sure that it
cannot be re-energized until all maintenance is complete.
Reorder labels and worn, damaged, or broken parts from quickjack.com/replacement-
parts.html . Only use factory-supplied parts as replacement parts.
All maintenance tasks can be performed by the owner/operator of the QuickJack.
To maintain your QuickJack
:
• Daily . Make a visual inspection of all moving parts and check for damage or excessive wear.
Replace any damaged or worn parts before equipment is put back into operation.
• Daily . Keep all QuickJack components clean.
• Daily . Make sure the Safety Locks are in good operating condition. Do not use your QuickJack if
the Safety Locks are damaged or excessively worn .
• Daily . Inspect Lift Blocks for damage or excessive wear. Replace as required.
• Weekly . Check all hose and fitting connections to make sure they are tight.
•
Monthly
. Lubricate all hinge points and check for excessive wear.
• Monthly . Check Air Cylinders to make sure they have the correct amount of pressure.
• Every other month . Check Hydraulic Fluid levels and refill if required.
•
When noticed
. Replace all caution, warning, and safety-related labels if illegible or missing.
Lubrication Points
QuickJack recommends using white lithium grease (or equivalent) and a grease gun with an
appropriate tip (a Lube-Link™, for example) for lubrication. Lubrication points are shown below.