122143 Rev. D
20
Q R I
K. FOOTREST HEIGHT ADJUSTMENT
To adjust the height of your footrest, use the appropriate size Hex wrench (A), and loosen the screw on both
footrest clamps. Slide the footrest up or down to the new desired height and tighten the two set screws. Use a
torque setting of 144 in-lbs (16.3 Nm). It is recommended that you maintain a minimum of 2.0 inches (5 cm)
between the lowest point on the footrest and the floor. This will provide adequate clearance for uneven surfaces
and prevent damage to your footrest.
L. BACK ANGLE ADJUSTMENT
Non-folding back instructions
1.
Remove backrest bracket bolt (B).
2.
Rotate the backrest to the desired angle.
3.
Align desired backrest bracket hole with seat frame opening.
4.
Reinsert bolt and tighten.
CAUTION – When changing the back angle of the wheelchair both the left and right angle adjustable back
bracket must be in the same hole position before the wheelchair is to be used.
Backrest Angle Preset Plugs
The preset plugs allow you to unemploy the backrest bracket holes you do not wish to use. This allows the
backrest to automatically lock into your desired angle position after unfolding.
1.
Determine which backrest bracket holes you do not want to use.
2.
Insert plugs (C) into the predetermined holes from the chair side of the bracket (D).
3.
To ensure the backrest will lock in the folded position, do not insert a plug into the lowest hole position
(E).
M. ADJUSTING REAR SEAT HEIGHT
To adjust rear seat height, loosen and remove the 6 cap screws ( F ) (3 per side) and nut plate ( G) that secure the
camber tube clamps (H) to the axle plates (I). Move both camber tube clamps (J) to the desired height and reinstall
the 6 cap screws that attach the camber tube clamps to the axle bracket. Then follow the instructions for setting the
toe-in/out to zero. Tighten screws to 144 in-lbs. (16.3 Nm).
NOTE– Adjustment to rear seat height may also require caster angle adjustment. See Caster adjustment section.
N. SEAT SLING ADJUSTMENT
Remove the screws (K) and rear nut (L) retaining the left side seat sling. Readjust VELCRO®-style material to
increase the tension in the seat sling. Replace screws and rear nut. If there is any difficulty in reattaching the
screws, try using a probe to help align the holes. Ensure that the plastic saddles are under the seat rail in all fas-
tener positions.
39
38
37
40
41
37
A
38
39
B
C
D
E
41
F
I
G
H
40
IX. DEALER SERVICE AND ADJUSTMENT
J
