930478 Rev. A
V . S e t - u p , A d j u s t m e n t & U s e
11
V . S e t - u p , A d j u s t m e n t & U s e
930478 Rev. A
10
J. CHECK-OUT
Once the tilt assembly is adjusted, it should actuate smoothly and easily.
All accessories should also perform smoothly.
1. Verify seat can achieve full tilt and will return to neutral.
2. Verify the motor cuts out once the neutral position is reached.
3. Verify no debris is interfering with the glide bearings.
4. Verify all hardware is securely tightened.
5. Verify that the drive lock-out switch is positioned to prevent driving if the
system is tilted to an angle of greater than 15°.
If the actuator stop switches are not properly adjusted, the actuator will cur-
rent limit or “stall” at the end of the stroke. Repeated “stall” conditions will
shorten the life of the actuator.
QTRONIX Power Module
E
A
B
D
F
H
G
Stereo Jack
G. BACKREST
A backrest angle adjustment is standard.
1. Adjustment on Seat Frame
a) Remove the front securing bolt (C) on the side
of the backrest hinge plate.
b) Loosen the lower rear bolt (D)
c) Set at desired angle. There are four holes (in 4º
increments) to choose from.
d) Reinstall the front bolt and tighten both bolts
securely.
H. SEAT HEIGHT ADJUSTMENT
The front seat height can be adjusted from 19.75" to
21.75" in 1" increments. Adjust front seat frame posts
(X) up or down to desired height.
The rear seat height can be adjusted to change the
seat angle relative to the front seat height. The com-
ponents to change rear seat height are include with
each P-220/P-222 SE. Installing 2 each of part number
540176 will elevate the rear 1" from standard.
Installing 2 each of part number 540177 will elevate
the rear 2". It is recommended that a qualified dealer
provide this service if desired.
I. TM40 SINGLE OR DUAL SWITCH ACTUATOR
CONTROLLER
(Refer to diagram on next page)
The TM40 actuator controller can be used to activate
the tilt mechanism with either single or dual switch
controls.
1. Plug limit switch harness assembly (A) into
TM40 limit switch jack (B).
2. Plug single switch into TM40 single switch jack
(D) OR plug dual switch (E) into TM40 dual
switch jack (F).
3. Plug TM40 into the QTRONIX Power Module (G).
4. Use mating plugs (H) to connect the TM40 to
the tilt actuator.
X
C
D
Содержание Integrated C.G. Tilt P-222SE
Страница 10: ......
