MK-100083 Rev. A
20
Q UI C KI E 5 R
IX. DEALER SERVICE & ADJUSTMENT
WARNING
The owner of this chair is responsible for making sure that it has been setup and adjusted by a trained service
professional under the advice of a healthcare professional. Service and/or adjustments should only be done
with the advice of a healthcare professional. Always use parts and/or accessories that have been recommended
and approved by Sunrise Medical when servicing this chair.
A. DEALER SERVICE INTRODUCTION
1.
At least once per year, this chair should have a complete inspection, safety check, and regular service
made by an authorized dealer. The tool list at right is a good starting point for proper maintenance.
2.
If you have discovered a worn, bent, or damaged part, repair or replace them with recommended parts
before returning this chair to service.
3
All major maintenance and repair work should be done by the authorized dealer.
B. CRITICAL MAINTENANCE TIPS
1. Torque settings:
A torque setting is the optimum tightening which should be made on a particular fastener. It is important to
use proper torque settings where specified. When not specified, torque settings should be
60 in-lbs
2. Dealer Service and Adjustment Reference materials:
Go to www.sunrisemedical.com for parts manuals, instruction sheets, and instructional videos that will aid in the
repair of your Quickie wheelchair.
C. CLEANING
1. Paint Finish
a.
Clean the painted surfaces with mild soap or detergent.
b.
Protect the paint with a coat of non-abrasive auto wax.
2. Axles and Moving Parts
a.
Clean around axles and moving parts with a slightly damp (not wet) cloth.
b.
Wipe off or blow away any fluff, dust or dirt on axles or moving parts.
c.
DO NOT USE 3-in-ONE oil, or WD-40
®
for lubrication. Only use Teflon based Lubricant when working
on this wheelchair.
D. REAR WHEEL AXLE NUT ADJUSTMENT
To adjust the rear axle you will need a 3/4" wrench (A) to turn the adjustment nut (B). You will also need a 1/2"
wrench (C) to securely hold the end (D) of the axle to prevent it from turning.
If the wheel and axle will not lock into the camber plug then the axle requires adjustment. Turn the nut (B)
counter-clockwise approximately 1/4 revolution and try to lock the axle into the camber plug. If it doesn't lock,
continue making small nut adjustments until it securely locks.
If the wheel is locked on the chair but there is excessive wheel play (the wheel hub can be pushed back and
forth on the axle) then adjust the nut (B) clockwise until there is no perceptible gap between the wheel and
camber tube. Make sure the detent ball (D) on the axle is securely locked onto the chair.
23
24
25
TOOLS YOU WILL NEED
1. Imperial hex key set
2. Metric hex key set
3. Imperial open-end wrench set
4. Metric open-end wrench set
5. Torque wrench
6. Imperial hex bit socket set
7.
Metric hex bit socket set
8. Phillips and flat screwdrivers
9.
Tire Pressure Gauge
23
24
25
A
B
C
D
D
B