19
EN
INSTALLATION AND USE MANUAL QUICK
XR7
- REV001A
XR7
3 - Introduction
• We recommend the use of the Quick® switch as the motor safety switch.
• Secure the chain with a further device before starting the navigation.
•
24 V
MODEL ONLY
: The reversing contactor unit must be installed in a point protected from accidental water
contact.
• After completing the anchorage, secure the chain to fixed points such as chain stopper or bollard.
• To prevent accidental releases, the anchor must be secured. The windlass shall not be used as the only securing device.
• Isolate the windlass from the power system during navigation (switch the circuit breaker off) and lock the chain securing it
to a fixed point of the boat.
• This device must not be used and installed by people (including children) with reduced physical, sensory
or mental capabilities. QUICK® SpA will not accept liability for direct or indirect damage caused by improper
use of the equipment.
3.2 Precautions for the installer
PROCEEDING WITH THE INSTALLATION IN GOOD LIGHT CONDITIONS.
We recommend using an appropriate personal protective equipment.
Windlass is not suitable for being installed in highly explosive.
Assembly and subsequent checks or repairs must only be carried out by qualified personnel.
THE PRODUCT MUST BE DISCONNECTED FROM THE ELECTRICAL SYSTEM BEFORE INSTALLING OR PROVIDING
MAINTENANCE.
Quick takes no responsibility regarding the inadequate connection of the users to the electrical system and to the safety of
the same.
4 - Installation
4.0 Installation requisites
The windlass must be positioned with the gypsy aligned with the bow roller.
Ensure that the upper and lower surfaces of the deck are as parallel as possible. If this is not the case, compensate the difference
appropriately (a lack of parallelism could result in a loss of motor power). The deck thickness must be included among the figures listed
in the table. In cases of other thicknesses it is necessary to consult a Quick
®
retailer. There must be no obstacles under deck to the
passage of chain; lack of depth of the chain locker could cause jamming.
max 5 mm
(3/16")
minimum
1,5m
(59”1/16)
Содержание XR7 Series
Страница 31: ......