11
3) Connect the
④
Plug into
⑤
Holder, then cover the
③
Heater with the
②
Steel pipe and
lock it.
4) Connect grounding cable and tighten it.
5) Install the replaced
③
Heater into the
⑥
Handle, lock the three
①
Screws.
6) Turn the spring counterclockwise until the handle is installed.
7) After replacing the heater, test the following parameters:
8) Calibrate the temperature, refer to Soldering temperature calibration.
13. Troubleshooting
No.
Error Message
Fault Descriptions
1
H-E
Indicates that there is a problem with the heater and the heater needs
to be
checked or replaced.
2
S-E
Indicates that there is a problem with the sensor and the sensor needs
to be
checked or replaced.
3
ERR
Indicates that the fan is faulty and needs to be checked
or replaced
.
