For support email [email protected] or call 518.452.5995.
UNBOXING
STEP 01
Do not plug in the machine.
Remove the drip tray grate (09) and locate the feet. Place a soft towel on your counter and tip
the machine gently backwards exposing the underside of the machine.
Put the four feet on the Vetrano 2B.
While the machine is resting on the soft towel on it’s back, while installing the feet, make sure
the water source switch (18) is in the intended position (right/0 = reservoir, left/I = plumb) This
is also where your LED light switch (19) lives (closest to the outside of the machine).
STEP 02
Test your water. Condition if needed with appropriate measures i.e.: 3rd wave water
(following manufacturers specifications), bottled, or an in-tank softening pouch (reservoir only).
Do not use distilled water or reverse osmosis systems.
STEP 03
RESERVOIR
If using reservoir: Access the reservoir by lifting the hinged door (01) on the back of the
machine. Rinse the reservoir with warm water, and make sure it’s securely seated in place.
You’ll know the reservoir has been seated appropriately when the low water alarm
stops sounding.
DIRECT PLUMB
Make sure the two switches (18, 20) on bottom of machine are in the ‘I’ position and follow the
instructions on the previous page.
STEP 04
Before plugging your Vetrano 2B Evo in, make sure the steam knob (03) and the hot water
knob (05) are completely closed and the brew lever is in the down position pushed as closely
to the front panel as possible.
STEP 05
If your machine was requested in 15A instead of 20A, please attach the included convertor
cord to the built-in cord on the Vetrano 2B Evo. This converter cord can be found in your
separate accessory box.
Only use the converter cord in 15A mode, failure to adhere to
this voids warranty and could cause fire.
