Input Signal Selection
Select this setting to play analog signals from a
cassette deck, VCR or turntable.
The T
est/Set Up button
Y
ou can adjust the relative loudness of the speakers
by TEST/SET UP button. In Dolby modes, press the
button briefly. A short noise will be heard in the
speakers one by one. The speaker playing the noise
at that moment will be shown in the display.
Speaker Configurations
Y
ou can also change the setup of the speakers by
pressing the TEST/SET UP button until the display
shows “LARGE” or “SMALL” which enables you to
set the size of the speakers.
Press again, “SW” will be displayed and you can
set the subwoofer on or off.
Displaying Program For
mats
When a digital source is playing, the receiver will
automatically switch to the proper surround mode
and indicates on the speaker icons on the right
hand side of the display.
It is important to note, however, that not all Dolby
Digital sources are encoded with full complement of
5 channels plus LFE*. Speaker icons show how
many and which speakers you have enabled and
the letters inside the speaker icons show which
channel is present in the source information.
*LFE stans for Low Frequency Effect. The indication “LFE”
appears if the digital source contains LFE information. In this
case, the bass signal will be delivered to the subwoofer,
offering more dynamic deep bass sound effects. If the letter is
flashing, the signal is either too weak or just gone.
ADV
ANCED SOUND CONTROL
19
Source Button
• SAT
• DVD
• CD
• VCR-1
• VCR-2
• TAPE
• TV
Available Input
ANL/Optical/Coaxial
ANL/Optical/Coaxial
ANL/Optical/Coaxial
ANL /-/-
ANL /-/-
ANL /-/-
ANL/Optical/-
