Quest Engineering Q300, Инструкция по эксплуатации, Страница: 12 / 27

21
TIME Time of day, date, month and year are set one item at a time. Setting and storing one value
advances to the next until all items have
been stored. The displays are shown as
follows:
XX:XX Time (24 hour military time)
dY:XX Day of the month
o :XX Month
199X Year
To set a value press:
SET indicator on Set desired value Store and go to
next value
After setting the last value, the SET indicator will turn off.
PDOSE Projected dose time. Set to desired number of hours for projected dose calculation, from 1 to 18
hours, displayed as XXHr.
To set a value press:
SET indicator on Set desired value SET indicator off
LH-0 Data Logging History turned on or off. LH-0 indicates
logging disabled, LH-1 indicates logging enabled. Disabling data logging saves memory while in RUN, allowing
more Events.
To set LH-0 or LH-1 press:
SET indicator on Set desired value SET indicator off
22
Security Features
SE20 Security mode for locking all setup parameters.
SE10 Security mode to lock unit operation while in RUN mode:
The last digit of either display can be a 1 or a 0. 1 indicates that security is enabled, and 0 indicates that security is
disabled. To enable or disable security, change the 0 to a 1, and enter a four digit code using the arrow and ENTER keys. After
correctly entering the last digit, the display will return to the SE11 or SE21 display. See section 2.7, Security, for details. To
enable either security feature, press the following keys: (example shows SE1)
SET indicator ON
Up or Down Arrow to change
SE10 to SE11 in display
"0---" in display
4x;
ª «
to set, and ENTER
to enter four digits
Returns to SE11 display
To disable security, press ENTER at the SE11 or SE21 display. Then enter the code which returns to the SE10 or
SE20 display.
InXX Printout Interval for shortening the printout when printing logged data, where XX is the number
of minutes of data combined into one data
point. Data is logged at one minute intervals.
Printout Interval may be set to 1, 5, 10, 15,
30 or 60 minutes. To set this value press:
SET indicator on Set desired value SET indicator off