Quest Engineering Flying ModelRocket KitL, Руководство по сборке, Страница: 2 / 10

A.
Place the Blue Thrust Ring up against the side of the Yellow
Motor Mount Tube and use it as a guide to cut a 1/8 inch long slit in
the side of the Yellow Motor Mount Tube as shown.
B.
Place the Yellow Motor Mount Tube up against the ruler provided
below. Make a pencil mark on the tube 1/2 inch from the uncut end
as shown, then draw that all the way around the tube's diameter.
C.
Insert the Motor Clip into the slit in the Yellow Motor Mount Tube.
D.
Wrap a piece of tape all the way around the Yellow Motor Mount
Tube to hold the Motor Clip in place.
Step 01
A.
B.
C.
D.
1/2 inch
MLAS
MLAS
Flying Model
Rocket Kit
A.
Apply a bead of wood glue around inside edge
of Yellow Motor Mount Tube as shown.
B.
Insert the Blue Thrust Ring into the Yellow Motor
Mount Tube so it is even with the end of the Yellow
Motor Mount Tube.
Step 03
Apply bead of Wood Glue here
Place Yellow Motor Mount
Tube here.
Place pencil mark on tube here.
Step 02
A.
Hold the Yellow Kevlar Cord and the White Shock Cord side by side. Pull one end of each cord so that they are
even with each other. While holding the two cords together, tie a single parallel overhand knot approximately one inch
from the ends as shown.
B.
Gently pull on both cords to
set the knot and prevent it from
slipping.
Yellow Kevlar
White Shock
Single Parallel
Overhand Knot
Knot
NOTE THIS IS A VERY IMPORTANT STEP. IF YOU TIE A DIFFERENT TYPE OF KNOT THE SHOCK CORDS MAY SEPARATE DURING FLIGHT!
C.
Apply a small amount of
Wood Glue on the ends of
both cords to prevent them
from fraying.
A.
Use two overhand knots to tie the Yellow Kevlar Cord around the Yellow Motor Mount Tube as shown.
Step 04
PAGE02 INCHES