GNSS Module Series
L26-DR EVB User Guide
L26-DR_EVB_User_Guide 15 / 28
4
EVB Operation Procedures
This chapter mainly illustrates the operation procedures of L26-DR EVB.
4.1. Communication via Micro-USB Interface
Step 1:
Connect the EVB and the PC with a Micro-USB cable through Micro-USB interface, and then
switch POWER to ON state to power on the EVB.
Step 2:
Run the USB flash drive on PC to install the USB driver. The USB port numbers will be viewed
in Device Manager of the PC after the USB driver is installed, as shown below.
Figure 10: USB Ports
Step 3:
Install and then use the QCOM tool provided by Quectel to realize the communication between
L26-DR module and the PC.
The following figure shows the COM Port Setting of QCOM: select the correct “
COM Port
” (USB
Port shown in the above figure) and set the correct “
Baudrate
” (the default value: 115200bps).
For more details about the usage of QCOM, please refer to
document [4]
.
Figure 11: COM Port Setting of QCOM
