QUATRO
Air Technologies Inc.
------------------------------------------------------------
We Make Clean Air
----------------------------------------------------------
30 Hymus Boulevard, Montreal, Quebec, H9R 1C9 Tel.: (514) 630-4444 Fax: (514) 630-4454 website:
5- CONTROLS
Type 1
– iSeries Controls
IMPORTANT NOTES FOR PROPER FUNCTION OF THE CONTROLS:
Do not connect the main power cord to an outlet that is controlled by a switch.
Never use any form of remote control that switches the power source on and off. In doing so, serious damage to the
controls and motors may occur. Contact
QUATRO
if power switching is the only way you have to remotely control the unit.
We have many power switching adaptors available for SAFE and reliable control.
“iSeries” Controls & Alarms/Status Conditions
The iSeries controls feature soft touch Power (On/Off), Speed Up & Speed Down Buttons. It also features a series of LEDs
that indicate the status of the filter(s) and motor(s) and inform you of any alarms. These alarms are accompanied by an
audible alert. See the table on the following page to understand the meanings of the LEDs and the alarms.
Alarms & Status Conditions
Alarm Mute Feature
All alarms can be muted for a period of 8 hours OPERATING TIME. After 8 hours the alarm will return and can be muted
again.
When mute is enabled, L1 Flashes & the muted alarms stay SOLID. The level of the alert will not be displayed until the 8
hour mute period is over.
To mute: Press SPD UP & DN quickly at the same time. When the buttons are released the alarm(s) will mute & L1 will
start flashing. Alarm LED will go SOLID.
If there are any additional alarms when MUTED, mute will disable itself until muted again, then BOTH alarms will be muted.
Muted alarms will only be displayed while the unit is in operation.
If the unit is turned off and then on during the 8 hour mute, the balance of the 8 hour mute will continue after the unit is
turned on again.
Service Filters
LED 3 (L3)
Circuit Breaker
System
ON
LED 1 (L1)
Service Motor(s)
LED 2 (L2)
LED 4 (L4)
Settings Menu
Only
Remote/Standby
LED 5 (L5)
Power Inlet
DB9 Remote
