4 Address Map and Special Registers
This chapter explains how the two UARTs and special registers are addressed,
as well as the layout of those registers. This material will be of interest to programmers
writing driver software for the DSC-200/300.
4.1 Base Address and Interrupt Level (IRQ)
The base address and IRQ used by the DSC-200/300 are determined by the BIOS
or operating system. Each serial port uses 8 consecutive I/O locations. The two ports
reside in a single block of I/O space in eight byte increments, for a total of 16
contiguous bytes, as shown in Figure 7.
Base A 8
to Base A 15
Port 2
Base A 0
to Base A 7
Port 1
I/O Address Range
Channel
Figure 7 --- Port Address Map
All two serial ports share the same IRQ. The DSC-200/300 signals a hardware
interrupt when any port requires service. The interrupt signal is maintained until no
port requires service. Interrupts are level-sensitive on the PCI bus.
The base address and IRQ are automatically detected by the device drivers
Quatech supplies for various operating systems. For cases where no device driver is
available, such as for operation under DOS, Quatech supplies the "QTPCI" DOS
software utility for manually determining the resources used. See page 17 for details.
Quatech DSC-200/300 User's Manual
14
