Manual Effect Controls
Effect
Result
Rainbow
Short Circuit
Paparazzi
Fire 1
Fire 2
Fire 3
Cop Light 1
Cop Light 2
Demo
Scroll through the Hue from 0° at full Saturation
Lamp is on with random bursts of turning off
Lamp is off with random flashes of turning on
A flicker effect with a low weighted center
A flicker effect with a middle weighted center
A flicker effect with a high weighted center
Solid Red and Blue alternating colors
3 Flashes Red, 3 Flashes Blue alternating colors
Scroll through the Hue from 0° at 0%, 25%, 50%,
75% and 100% Saturation at 2000k and 6000k
Effect
Result
Effect
Rate
Maximum
Minimum
Choose Effect
0-200% for the speed
of the effect
100% is normal speed
Highest intensity level
of effect
Lowest intensity level
of effect
Effects
To Set the Intensity, Color Temp, +/- Green, Saturation and Hue:
Press the Left or Right arrows until desired function is selected.
Press Enter to Select.
The selection carrots > < will move from the >Function< to the >Value<
Press the or buttons to set the value. Press Enter to Save.
On parameter menus such as intensity, saturation, and hue, when pressing and holding the
button to increase the value, tap the button will jump to the next value or max value. The
opposite is true when decreasing.
Press and hold the Enter for 5 seonds to disable the status lights.
-
+
Manual Button Shortcuts
Linear LED
Q
-
Rainbow RGBX
Solid Green Light - Lamp is paired and receiving transmission.
Slow Flashing Green Light - Wireless DMX is paired but transmitter not found.
Fast Flashing Green Light - Wireless DMX is in pairing.
No Green Light - Lamp is Unpaired or Wireless/Status Lights are turned off.
Solid Red Light - Data Received
No Red Light - No Data Received or Wireless/Status Lights are turned off.
Status Lights
DMX
Data
-
+
DMX
Data
-
+
DMX
Data
-
+
DMX
Data
Lead/Follow Mode allows one Rainbow lamp to control many lamps at once. The Lead transmits
DMX data wired or wirelessly to the followers. When the Lead changes levels, the follows will
change as well. Applies to on board FX as well.
To Lead/Follow Mode, go to Config->Lead/Follow. Set the Leader to Lead and set all of the
Followers to Follow 1 to match the leader. Follow 2-6 is used with effects to do the same effect with
different timings.
To use wired, plug Cat5 cable into the Out of the Lead into the In of the Follow. Repeat out of the
follow and into the next. The data light should be illuminated on all the followers
To use wirelessly, on the Follows, press and hold the Link button to Unpair the lamp. Next tap
the Link button on the Lead. All of the follows Wireless signal light should begin flashing and
then remain solid.
Lead/Follow Mode
MODE
Lead
MODE
Follow 1
MODE
Follow 1
M
M
M
M
M
M
M
M
M
M
M
M
M
M
M
M
M
M
M
M
M
M
M
M
