Q
-
Rainbow RGBX
Linear LED
15 |
P a g e
Wireless Pairing
To Link a Rainbow lamp to a transmitter,
Go to Config->Wireless, Set to ON, Config->Status Lights to ON
If the Wireless DMX is flashing, press and hold the
Link button to Unpair.
On the DMX Transmitter, tap the Link button to Pair.
The Wireless DMX Light will start to Flash and turn solid once paired.
Mode: Lead / Follow
Lead/Follow Mode allows one Rainbow lamp to control many
lamps at once. The Lead transmits DMX data wired or wirelessly
to the followers. When the Lead changes levels, the follows will
change as well. Applies to on board FX as well.
To use Lead/Follow Mode, go to Config->Lead/Follow. Set the
Leader to Lead and set all the Followers to Follow 1 to match the
leader. Follow 2-6 is used with effects to do the same effect with
different timings. This will run the same effects, intensities and
levels but not in sync.
To use wired, plug Cat5 cable into the Out of the Leader into the
In of the Followers. Repeat out of the Followers and into the next. The data light should
be illuminated on all the followers.
To use wirelessly, on the Followers, press and hold the Link button
to Unpair the
lamp. Next tap the Link button
on the Leader. On all the Followers, the Wireless
signal light should begin flashing and then remain solid.
