Quantum UC1000, Руководство по установке

Страница: 2 / 4

UC1000 Installation Guide
www.danamark.com
DANAMARK WATERCARE
90 Walker Drive, Brampton, ON L6T 4H6 | 1 888 DANAMARK | T 905 792 2353 | F 905 792 2986
Item Part Number Description Qty
A Q1000 Quantum 1000 Filter Cartridge 1
B QH3 Quantum Head 1
C* 3046-44 Mounting Bracket 1
D* 3081-31 Restrictor Fitting (Outlet) 1
E* PI011223S Male Connector (Inlet) 1
F CI3208U7S Faucet Connector 1
G FCTT8-520 Teflon Tape 1
H PPASV121208W Angle Stop Adaptor 1
I MS1034 SS Mounting Screws (Phillips) 2
J TBL14 ¼” Blue Waterline 10’
K 9970-56 Designer Series Chrome Faucet 1
*Installed on (B) Quantum Head
Item Description Qty
K1 Brass Escutcheon (with O-Ring) 1
K2 Black Locating Washing 1
K3 Lock Washer 1
K4 Nut 1
K5** Compression Nut 1
K6** Tube Support/Insert 1
K7** Delrin Sleeve 1
**Used in place of (F) CI3208U7S for compression fitting installations
A
B
C
E D
K
F
H
G I
J
(K1) Brass Escutcheon &
Rubber O-Ring
Countertop
(K3) Lock Washer
(K4) Nut
(F) Faucet Connector
(K2) Black locating washer
Use tapered side down for ½” hole
Contents
Contents of Designer Series Chrome Faucet
(Part # 9970-56)
Thank you for purchasing a Danamark Quantum Under Counter
Drinking Water System. Rest assured that you have purchased the very
finest in point-of-use water purification. Should you have any questions
or concerns, please call us at:
1-888-DANAMARK (1-888-326-2627)
Preparation For Installation
: *Important: Use only on cold water supply *
1.
Shut off cold water supply to sink.
2.
Relieve line pressure by opening the cold water tap for a few seconds until water stops; then close the tap.
3.
Select a suitable location to mount (B) Quantum Head and (A) Cartridge, leaving approximately 2” of space
below cartridge for ease of future cartridge changes.
4.
Select a suitable location to mount (K) Chrome Faucet, minimum of 1” from edge of the sink.
Tools Required:
-
Phillips screwdriver
-
½” Drill bit and drill
-
Adjustable wrench
Installation of Faucet:
1.
When drilling the countertop; place the (K1) Escutcheon plate,
with dome face up, 1/8” from the back of the countertop and a
minimum of 1” from the edge of the sink. Use as a template to
drill a ½” hole.
2.
Assemble faucet as shown on diagram to the right.
3.
Wrap threaded faucet stem with the provided (G) Teflon tape.
4.
Tighten (F) Faucet Connector to the threaded faucet stem.