Quantum StorNext QD6000, Руководство по замене, Страница: 7 / 8

3
9. Remove the ESM canister from the drive tray (
Figure 2
) by pressing the orange tab toward the black tab, moving the
levers to the outside, and then pulling the ESM canister toward you.
Figure 2 Removing an ESM Canister
While removing the ESM canister, you might notice an increase in fan speed. The fan speed returns to normal after you
have replaced the ESM canister.
10. Slide the replacement ESM canister all the way into the drive tray until the tab on the ESM canister latches.
11. Reconnect all the cables to the replacement ESM canister.
12. Check the ESM Power LED and the ESM Service Action Required LED on the new ESM canister (
Figure 1
on page
2
).
13. Based on the LED status, perform one of these actions:
—
The ESM Power LED is on and the ESM Service Action Required LED is off
– Go to step
15
.
—
The ESM Power LED is off or the ESM Service Action Required LED is on
– Check that the ESM canister is
installed correctly. Reinstall the ESM canister. Go to step
14
.
14. Did this action correct the problem?
—
Yes
– Go to step
15
.
—
No
– If the problem has not been resolved, contact your Technical Support representative.
15. Check the status of all of the trays in the storage array.
16. Does any component have a Needs Attention status?
—
Yes
– Click the
Recovery Guru
toolbar button in the Array Management Window, and complete the recovery
procedure. If the problem has not been resolved, contact your Technical Support representative.
—
No
– Go to step
17
.