Quantum QT-730 Series, Инструкция по установке и эксплуатации

Страница: 27 / 46

Model QT-730 Radiographic Table
Chapter 3 Assembly & Installation
3. Install the Receptor Cabinet as follows:
a. Loosely attach the two (2) Front Receptor Bearing Brackets to the Re-
ceptor Cabinet, as shown in Figure 4, using three (3) 1/4-20 x 3/4” pan
head screws (bracket with handle mounts to right side of cabinet).
b. Through the opening in the top of the table, insert the Front Receptor
Bearings so they rest on the front bearing track (see Figure 5). Care-
fully, lower the back end of the Receptor Cabinet so it rests on the Ta-
ble Top Frame (where it mounts to the Table Base) as shown in Figure
6).
c. Insert the left Rear Receptor Bearing Brackets through the slot at the
far right end of the rear bearing track as shown in Figure 7. Repeat for
the right Rear Receptor Bearing Bracket.
d. Loosely attach the left and right Rear Receptor Bearing Brackets to the
back end of the Receptor Cabinet using two (2) 1/4-20 x 3/4” pan head
screws on each.
RECEPTOR BEAR-
ING BRACKET (2X)
1/4-20 X 3/4” PAN
HEAD SCREWS (3X)
Figure 4. Installing the Front Receptor Bearing Brackets
15