Quantum NE PLUS, Основные инструкции по эксплуатации

Страница: 12 / 20

12
Battery Condition Meter
The battery condition meter consists of a 7-segment display on the LCD. As the battery voltage drops,
the number of lights reduces from top to bottom. When the battery capacity drops to 10% or below, the
bottom segment will flash.
„
Bottom Segment Flashing: The battery charge is low; charge the batteries as soon as possible.
„
Upward Ripple of Segments with Charging Plug: The controller is in charging mode.
„
All or No Segments Flashing Quickly (Code): The controller has detected a fault; refer to the Error
Code table.
Right/Left Turn Indicator Buttons (for Optional Equipment)
The right/left turn indicator buttons toggle either the left or right turn indicators. Press once to turn on and
press again to turn off. You can also turn off the selected turn indicator by pressing the opposite indicator
button or the hazard button.
Light Button (for Optional Equipment)
The light button turns the headlights/taillights on and off independent of other indicators.
Hazard Button (for Optional Equipment)
The hazard key activates both turn indicators at the same time. You can cancel this only by pressing the
hazard button again.
Power Accessory Indicators (for Optional Equipment)
Indicates the selected power accessory. This is only for optional accessories.
NOTE: If your power chair is equipped with power accessories such as a power elevating seat or
power elevating leg rests, you can operate them through the keypad buttons, joystick, mono jack
switch, and attendant control. Refer to “Actuator Adjustment.”
Controller Connector
This connects the NE+ controller to the power module located on the power base.
Off-Board Charger/Programming Socket
You may use an off-board charger to charge the power chair batteries through the 5-pin socket located
on the front of the NE+ controller. If you use an off-board charger, the charger current should not exceed
8 amps. Contact your Pride/Quantum Rehab Provider for more information.
WARNING! Only chargers with Neutrik NC3MX plugs should be connected to the off-board charger/
programming socket. See your Pride/Quantum Rehab Provider for more information.
NOTE: The socket may also be used for reprogramming the NE+ controller. Contact your Pride/
Quantum Rehab Provider for more information.
Speed Adjustment/Profile Select
To select a speed setting or drive profile:
1. Press the on/off button to power on the controller.
2. Press the drive profile decrease or drive profile increase button until you reach the desired speed/
profile setting.
NOTE: Drive profiles are set by your Pride/Quantum Rehab Provider. Contact your Pride/Quantum
Rehab Provider to change a drive profile or change speed settings.