page 3
INSTALLATION and WIRING (CONTINUED)
4
5
Housing attachment to mounting plate:
Make certain all wires and connectors are
routed to avoid interference with other
components. Align latch openings on
underside of housing with latch buttons
on mounting plate. Firmly push housing
straight onto mounting plate, making
certain all four latches are fully engaged,
and the housing is closely aligned to the
mounting surface.
FINAL ASSEMBLY
Battery Connection
Note: some details may vary
Connect the polarized battery plug to
the charger board. Make certain that
the battery cable is routed to avoid
interference with the AC input
connector or other components.
Federal Communications
Commission (FCC) Requirements:
This device complies with FCC Title
47, Part 15, Subpart B. This device
may not cause harmful interference.
battery connector
Battery Type
Total Load
NiCd
6.6W
LiFePO4 (LTP)
11.0W
LiFePO4 (LTP HO)
22.0W
LiFePO4 (LTP EHO)
33.0W
CLSR
Module
Antenna
Battery
Lamp
Lamp
DC output to the remote units.
Yellow/Red stripe (+) Blue/Black stripe (-)
Input from branch circuit. See label on
wire pair for voltage requirement.
Status Indicator LED
Remote test Option
(standard with SDRT)
Test Switch
WIRING DIAGRAM
Antenna
Input
Voltage
Pin
No.
Wire color
Wire Label
Battery
Type
120V-
347V
1
White
NiCd
3
Black or
Orange
HOT
120V-347V
5V-30V
2
Yellow or
Red stripe
LTP
Only
4
Blue or
Black stripe
PIN 1
PIN 3
PIN 2
PIN 4
Top view
