page 3
INSTALLATION and WIRING (CONTINUED)
4
5
Housing attachment to mounting plate:
Make certain all wires and connectors are
routed to avoid interference with other
components. Align latch openings on
underside of housing with latch buttons
on mounting plate. Firmly push housing
straight onto mounting plate, making
certain all four latches are fully engaged,
and the housing is closely aligned to the
mounting surface.
FINAL ASSEMBLY
Battery Connection
Note: some details may vary
Connect the polarized battery plug to
the charger board. Make certain that
the battery cable is routed to avoid
interference with the AC input
connector or other components.
Federal Communications
Commission (FCC) Requirements:
This device complies with Part 15 of
the FCC Rules. This device may not
cause harmful interference.
battery connector
Battery
Lamp
Lamp
Status Indicator LED
Remote test Option
(standard with SDRT)
Test Switch
CAUTION:
CAP UNUSED LEADS
WIRING DIAGRAM
Battery Type
Total Load
NiCd
2.4W
LiFePO4 (LTP)
4.8W
Input from branch circuit. See label
on wire pair for voltage requirement.
DC output to the remote units. See label on wire
pair for positive and negative polarity colors
