Quantum DXi6902, Руководство по обслуживанию на месте, Страница: 213 / 242

Chapter 3: DXi6902 FRU Removal and Replacement Procedures
Replacing an Expansion Module ESM Canister
Quantum DXi6902 User’s Guide 189
Figure 119 Removing and
Installing an Expansion Module
ESM Canister
Installing a Replacement Expansion Module ESM
To install the replacement Expansion module ESM canister:
1 Slide the replacement Expansion module ESM canister into the
empty bay until the canister snaps into place, and push the handles
into the closed position (see Figure 119 ).
2 Connect the SAS cables to the new ESM canister (see DXi6902
Cabling Diagrams on page 211):
3 Update the ESM canister firmware:
a Access the Service Menu (see Accessing the DXi6902 Service
Menu on page 34).
b Navigate to Hardware Configuration > Setup external
Storage > Upgrade Array Firmware > Upgrade ESM (EBOD)
firmware .
c Follow the prompts to update the ESM firmware. Make sure to
specify the correct Array module and Expansion module.
Expansion Module controller handles