Quantum DXi6902, Руководство по обслуживанию на месте, Страница: 180 / 242

Chapter 3: DXi6902 FRU Removal and Replacement Procedures
Replacing the Node
156 Quantum DXi6902 User’s Guide
PCIe slot 2 (see Replacing an Expansion Card in Riser 1 on
page 110).
Note: You do not need to remove any other expansion cards from
the failed Node. All other required expansion cards are pre-
installed in the replacement Node.
Installing a Replacement Node
To install the replacement DXi6902 Node:
1 Install the hard drives from the failed Node in the correct locations
in the replacement Node (see Replacing a Node Hard Drive on
page 86).
Caution: You
must
install each hard drive in its correct location.
If the hard drive locations are not correct, the system
will not function.
2 If applicable, install the optional dual port 10 GbE card (along with
any associated SFPs) or optional quad port 1 GbE card in PCIe slot 2
in the replacement Node (see Replacing an Expansion Card in Riser 1
on page 110).
3 Install the replacement Node in the rack (see Opening and Closing
the Node ).
4 Turn on the system (see Turning On and Shutting Down the System
on page 21).
5 If Data-at-Rest Encryption is enabled, configure the PERC H710
integrated storage controller for encryption (see Enabling Data-at-
Rest Encryption on a Replacement Integrated Storage Controller on
page 120).
6 Run Factory Detect Hardware from the Service Menu to detect the
new hardware (see Factory Detect Hardware on page 40).
7 Install the original system serial number on the new Node:
Note:
The system serial number is located on the label holder
affixed to the upper right corner of the rear of the Node.
The system serial number includes the letters
BVT
.