Quantum DXi6902, Руководство по обслуживанию на месте, Страница: 130 / 242

Chapter 3: DXi6902 FRU Removal and Replacement Procedures
Replacing Node Expansion Cards
106 Quantum DXi6902 User’s Guide
5 Run Factory Detect Hardware from the Service Menu to detect the
new hardware (see Factory Detect Hardware on page 40).
6 Log on to the remote management console as the service user (see
Turning On and Shutting Down the System on page 21).
7 Navigate to the Service > OpenManage page, and then click
Launch OpenManage .
The OpenManage Login window displays.
8 Enter the following login credentials and click Submit :
• Username - root
• Password - Contact Quantum ASPS for the service password.
The OpenManage Server Administrator window displays.
9 In the left pane, navigate to System > Main System Chassis >
Memory (see Figure 57 ).
10 Verify that the value for Total Installed Capacity Available to the
OS is the expected value (128 GB or 256 GB).
Note: If the value is less than expected, one or more of the
memory modules may not be installed properly. Shut down
the DXi6902, then repeat this procedure, checking to
ensure that the memory modules are firmly seated in their
sockets.
11 In the remote management console, delete any administrative alerts
and close any service tickets.
Replacing Node Expansion Cards
This section describes how to remove and replace PCIe expansion cards
in the DXi6902 Node and contains the following sections:
• Identifying Expansion Card Locations
• Obtaining a Replacement Expansion Card
• Replacing an Expansion Card in Riser 1