Quantum DLT 4700, Руководство по эксплуатации продукта

Страница: 43 / 360

Installing and Configuring the DLT4000 Tabletop Drive
DLT4000/DLT4500/DLT4700 Cartridge Tape Subsystem 2-9
2.6 Test the Installation
Section 2.6 includes the following topics:
Topic Section
Run the Power-On Self-Test (POST) 2.6.1
What to Do after POST 2.6.2
2.6.1 Run POST
To test the installation for the DLT4000 tabletop drive by running POST:
1. Turn on the system power.
2. Set the power switch on the DLT4000 rear panel to on. POST runs automatically.
3. Observe the indicators on the DLT4000 front panel. Ensure the indicator
sequence of events is the same as in Table 2-2 . Events on the right and left sides
happen at the same time.
Table 2-2 POST
Event Action
1
The indicators on the right front panel turn on sequentially from
top to bottom. All indicators stay on for a few seconds.
2
All indicators on the left front panel turn on at the same time for
about three seconds and then turn off.
3
The green Operate Handle, the orange Write Protected, and the
Yellow Use Cleaning Tape indicators turn off. The yellow Tape
in Use indicator blinks while the tape drive initializes.
4
After initialization, if no cartridge is loaded, the yellow Tape In
Use indicator turns off, the green Operate Handle indicator turns
on, the handle unlatches, and the beeper sounds.
For more information on what happens after initialization when a cartridge is present,
but the handle is down; or a cartridge is present, but the handle is up (not
recommended), see Section 3.5.4 in Chapter 3.