Quantum ATL 7100, Руководство по установке

Страница: 37 / 68

Chapter 2 Unpacking and Moving the Library
Packaging the Library for Reshipment
Quantum|ATL 7100 Series Facilities Planning and Installation Guide 21
Packaging the Library for Reshipment
2
If it becomes necessary to crate the library for shipment, use the
procedure below and refer to the figures in this chapter.
1
Open the storage array door.
2
Gently lift the extension axis up and place the vertical axis
block in position (see
figure 9) , then lower the extension axis to
the bottom position.
3
Install both the top and bottom horizontal axis blocks.
4
Gently slide the robotic mechanism towards the rear of the
library so that is up against the horizontal axis packing blocks.
5
Install the tie-wraps securing the extension axis for shipment
(see
figure 8) .
6
Close the storage array door.
7
Raise the leveling feet by rotating each foot counterclockwise
(as viewed from above) until they are fully retracted.
8
Move the library to the crating area observing all guidelines
described in
Moving the Library to the Final Installation Area
on page 17.
9
Slide out the two pallet ramp sections (located underneath the
library) and secure them to the pallet using the Velcro straps
(see
figure 7 on page 15).
10
Unfold the shipping bag and align the white tape to the pallet
bottom with respect to where the library casters will roll onto
the pallet.
Note:
This procedure assumes that all cartridges have been
removed, power is off and cables are disconnected.
Caution:
Observe proper ESD protective measures to prevent
damage to the library.