Quantum ActiveScale X100, Руководство по установке

Страница: 135 / 265

ActiveScale™ OS X100 Rackless Installation Guide
135
• For uplink mode 1 (two individual 10G access ports (48,47) per System Interconnect):
– Connect transceivers to ports 48 and 47 on each System Interconnect, on each system, at each site.
• For uplink mode 2 (one 10G trunk port (48) per System Interconnect):
– Connect transceivers to port 48 on each System Interconnect, on each system, at each site.
• For uplink mode 3 (one 40G trunk port (50) per System Interconnect):
– Connect transceivers to port 50 on each System Interconnect, on each system, at each site.
• For uplink mode 4 (three 10G trunks ports (48,47,46) with LACP per System Interconnect):
– Provide non-conflicting VLAN IDs and configure your respective switch ports for LACP.
– Connect transceivers to ports 48, 47, and 46 on each System Interconnect, on each system, at each
site.
• For uplink mode 5 (two 40G trunks ports (52,50) with LACP per System Interconnect):
– Provide non-conflicting VLAN IDs and configure your respective switch ports for LACP.
– Connect transceivers to ports 52 and 50 on each System Interconnect, on each system, at each site.
Figure 10
-
26. Uplinks illustrated
Table 10
-
4. System Interconnect uplink ports
Local device Local port Your network
System Interconnect 1 (
SW1
)
48 Site
N
_SystemNetwork1
System Interconnect 1 ( SW1 ) 47
Site
N
_Column1_StorageNetwork1
System Interconnect 2 (
SW2
)
48 Site
N
_SystemNetwork2
System Interconnect 2 ( SW2 ) 47
Site
N
_Column1_StorageNetwork2