Quantum ActiveScale P100E3, Руководство по подготовке площадки и требованиям

Страница: 11 / 17

ActiveScale™ P100E3 Site Requirements Guide
11
2 ActiveScale P100E3 site requirements
This section describes the power, environmental, and space requirements for the ActiveScale P100E3.
Topics:
• Warnings and cautions on page 11
• Environmental requirements on page 11
• Rack requirements on page 11
• Delivery route inspection on page 12
• Build space requirements on page 12
• Servicing space requirements on page 13
• PDU requirements on page 14
• Network requirements on page 14
2.1 Warnings and cautions
To avoid personal injury or property damage, adhere to the safety instructions and information in the
section Regulatory and Safety Document.
2.2 Environmental requirements
The front and rear of the system must be clear of any materials that could block or disrupt system airflow.
Disruption of airflow can cause performance issues or system damage due to overheating.
2.2.1 Airflow requirements
Use the following guidelines to ensure proper system airflow:
• The airflow in and out of the equipment must not be restricted.
• Controlled air conditioners that are functional and can sufficiently maintain specified system
operating temperatures should be located in the facility where the system will be installed.
• If rack doors will be used, ensure that the solution used with the system does not prevent airflow from
the cold aisle from entering the system freely.
2.3 Rack requirements
The ActiveScale P100E3 is installed into a customer-supplied rack. Use the guidelines in this section to
choose an appropriate rack mounting solution.
Important: The absolute minimum depth requirement for the ActiveScale
P100E3 is 42.12 in (1070 mm). However, Quantum Corporation recommends
selecting a rack with a minimum depth of 48 in (1200 mm) to allow for proper
PDU installation and cable routing.
Use the following additional guidelines when choosing a rack mounting solution for the ActiveScale
P100E3: