Quantum Rehab Quantum 500, Руководство пользователя

Страница: 25 / 47

Quantum 500 www.quantumrehab.com 25
Armrest Width Adjustment
You can change each armrest’s width independently of the other.
NOTE: Changing the armrest width may increase the
overall width of your power chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the arm-
rest receiver bracket. See figure 14.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to
the floor. See figure 14.
2. Loosen the jam nut.
3. Turn the adjusting screw clockwise to raise the front of
the armrest, or turn the adjusting screw counterclock-
wise to lower the front of the armrest.
4. Tighten the jam nut to lock the adjusting screw into place.
Controller Position
You can position the controller for either left-hand or right-
hand use.
WARNING! Do not place the controller
cable so that it can be pinched in the seat
frame or the power base frame.
To change the controller position:
1. Turn off the power to the controller.
2. Loosen the rear shroud fasteners.
3. Remove the rear shroud.
4. Unplug the controller connector(s) from the power base.
5. Cut the wire tie(s) securing the controller cable to the armrest.
6. Loosen the mounting screws in the mounting block. See fig-
ure 15.
7. Move the controller mounting block and controller to the
other armrest and tighten the mounting screws.
NOTE: For contour seats, loosen the setscrew on the
underside of both armrests, transfer the controller, and
tighten the setscrews. See figure 16.
8. Route the controller cable to the back of the power
base and plug in the controller.
V . C O M F O R T A D J U S T M E N T S
Figure 15. Controller Position - Mounting Block Shown
SETSCREWS
Figure 16. Controller Position - Underside of Armrest
SETSCREW
MOUNTING
SCREWS
MOUNTING
BLOCK