Quantum Design CM-C, Руководство пользователя

Страница: 43 / 54

Chapter 6 Section 6.4
VSM Oven Software MultiVu and VSM Oven-Enabled Software
Quantum Design VSM Oven Option User’s Manual, Rev. A3
6-3
May 2011
the very low thermal mass of the heater stick and the ease with which temperature can be
controlled.
6.4.2 VSM Control Center Components
Figure 6-1 shows the
VSM Control Center
(in oven mode (“[oven active]”).
Figure 6-1. The VSM Control Center (oven enabled) after sample installation has been completed
6.4.2.1 STATUS AREA
The
Status
area at the bottom of the
VSM Control Center
includes new information such as the
measurement mode you selected during the
VSM Install/Remove Sample Wizard
. For example,
after you select VSM Oven mode and complete the
VSM Install/Remove Sample Wizard
, the
Status
area will report "Oven Active" and "VSM Oven Selected" (Figure 6-1). If you had
selected standard VSM mode, the
Status
area would display "Standard VSM configuration
selected."
6.4.2.2 THE VSM INSTALL/REMOVE SAMPLE WIZARD
The
VSM Install/Remove Sample Wizard
(
VSM Install
wizard for short) organizes the oven
and sample-installation process through a set of automated dialog boxes. You start the
VSM
Install
wizard by clicking on the
Install/Remove Sample
button located in the lower left of the
Install
tab (Figure 6-1). The initial pages of the
VSM Install
wizard for the VSM Oven-
enabled software are somewhat different than those for the standard VSM software, most
notably by including a dialog in which you choose to operate in Oven mode or standard VSM
mode (Figure 6-2).