Quantronix Cubiscan 110-XT, Руководство по эксплуатации и техническому обслуживанию

Страница: 36 / 78

Zero (button)
Tap this key to reset the sensors and scale to “zero” (make sure the
platform is empty). Refer to
“Zeroing the Cubiscan 110-XT” on page 26
.
Measure (button) Tap this key to prompt a measurement. The weight and dimensions of the
object on the platform will be displayed on the screen.
Take the following steps to measure and weigh a package using the
touchscreen to control the Cubiscan.
1. Verify that the Cubiscan platform is empty. The
->0<-
indicator should
be lit, and
0.00
should be displayed in the
Wgt=
field. Except for the
Factor
field, the rest of the display should be clear.
2. Place the package or object to be measured and weighed on the
platform and slide it against the center of the back panel. The
->0<-
indicator light should go out.
N
OTE
Do not lean on or touch the Cubiscan platform or the package while a package is
being cubed and weighed. Any kind of contact with the platform during the
measurement process can alter the weight or sensor reading.
3. Tap
Measure
. The length, width, height, weight, and dim weight of the
package are displayed. The factor used to determine the dim weight is
also displayed.
4. Remove the package from the platform. Wait for the
->0<-
indicator to
light before placing the next package on the platform.
If the
->0<-
does not light, it means that the scale needs to be zeroed. To
zero the scale, make sure that the platform is free of all objects, then press
Zero
.
Zeroing the Cubiscan 110-XT
Tap the
[Zero]
button on the touchscreen to “zero” the Cubiscan 110-XT
(set all empty measurements and weight to zero). The Cubiscan 110-XT
tries to zero itself automatically every five seconds when it is not in the
Measure mode. However, you may need to use this option in the following
circumstances.
•
If, during a long measuring session, environmental conditions
(temperature and humidity) have changed noticeably.
•
If you suspect that the last zeroing was in error (something was on the
platform).