Quanser QNET 2.0 HVAC Скачать руководство пользователя страница 2

Страница: 2 / 4

+15V

-15V

+5V

External Power

24V 2.0A

Set up the Hardware

STEP 4

Ensure that the NI ELVIS II power switch
is in the OFF position.

Place the handle on the front of the QNET
board over the bracket located on the front
of the NI ELVIS II.

Slide the PCI connector at the back of the
QNET board into the female connector on
the NI ELVIS II.

To set up the QNET HVAC, please read the following instructions carefully. For full details, see the QNET HVAC User
Manual.

Connect the NI ELVIS II power supply
to the back panel of the NI ELVIS II.

Use the NI ELVIS II USB cable to connect
the NI ELVIS unit to your computer.

Connect the QNET HVAC power supply.

+15V

-15V

+5V

External Power

24V 2.0A

+15V

-15V

+5V

External Power

24V 2.0A

Содержание QNET 2.0 HVAC

Страница 1: ...quired add ons are installed 1 LabVIEW 2012 or later 2 NI DAQmx 9 5 5 or later 3 NI ELVISmx 4 4 or later 4 LabVIEW Control Design and Simulation Module 2012 or later Note The QNET curriculum resources...

Страница 2: ...r at the back of the QNET board into the female connector on the NI ELVIS II To set up the QNET HVAC please read the following instructions carefully For full details see the QNET HVAC User Manual Con...

Страница 3: ...If not consult the troubleshooting section at the end of this guide Testing the QNET HVAC STEP 5 C H Ensure that the 15V 15V 5V and the External Power LEDs on the QNET board are lit Ensure that LEDs o...

Страница 4: ...d on the back panel of the NI ELVIS II unit and the prototyping power switch situated on the top of the NI ELVIS are ON If one or more of the 15V 15V or 5V LEDs is still not lit then the 15V or 5V fus...