5
Installing a MEM
XLS Library Installation Manual
5-11
6.
Once the equipment is level, turn the four jam nuts on the MEM and the four jam
nuts on the LRM clockwise until they push up against the frame. See
5.7
Installing the Side Panel on the MEM
To install the side panel on the MEM, follow these steps:
1.
Holding the side panel with both hands, place the panel next to the MEM and
carefully lower it until the hooks on the panel engage with the corresponding
slots on the MEM’s frame.
2.
Insert the two screws in the holes at the bottom of the panel. See
.
3.
Using a #2 Phillips screwdriver, tighten the screws.
4.
After installing the MEM, install and connect the tape drives, then power on the
XLS as described in
Chapter 9, “Applying Power and Logging Into X-Link.”
Figure 5-14
Tightening a leveling foot
Figure 5-15
Installing the side panel on the MEM
Turn jam nut until
it pushes against
the frame
Содержание XLS-810160
