3
OPErAtiON BY tHE
rEMOtE cONtrOl
Plug in your electric fireplace heater and it will beep
once, this means you have power and your remote is
ready to operate your electric fireplace heater.
: Standby button. Press this button once the
unit becomes energized and you can select
the following functions as desired. Press this
button again, the unit will turn OFF and enter
standby mode.
:
Press this button once for flame effect. The
unit will be beep and the indicator light will be
ON. The bulbs for flame effect will turn ON. To
adjust the flame intensity, hold down the button
- the flame optics will go higher or lower. Once
you have found the desired setting, release the
button. Pressing the button again will stop the
flame effect.
750W:
Press this button for low heat level. The unit
will beep, the pilot light and indicator light will be
on. The electric fireplace heater will give low heat
level. Pressing once again will stop the low heat level
function.
1500W:
Press this button for high heat level. The
unit will beep, the pilot light and indicator light will be
on. The electric fireplace heater will give high heat
level. Pressing once again will stop the high heat level
function.
rEMOtE cONtrOl BAttErY rEPlAcEMENt
Replace with 2 AAA batteries.
WARNINg: do not mix old and new batteries. do not mix alkaline, standard
(carbon-Zinc), or rechargeable (Nickel cadmium) batteries.
MAiNtENANcE
WARNINg: disconnect power and unplug the power cord before attempting
any maintenance or cleaning to reduce the risk of fire, electric shock or
damage to persons. The bulbs in your unit can become extremely hot. Allow
at least 10 minutes between turning off the unit and removing the light bulbs
to avoid the accidental burning of the skin.
RIsK Of fIRe: dO NOT exceed The RecOMMeNded BulB WATTAge.
rEPlAciNG tHE liGHt BUlBS
Step 1: Remove the front cover by pulling it upward until the front cover has been
removed from the 4 locking posts located on both sides. See Fig. E.
locking posts
locking posts
locking posts
locking posts
front cover
fig. E
Step 2: Then remove the rock bed from the fireplace. See Fig. F.
fig. F
Step 3: Remove the lower cover by loosening 11 screws as shown in Fig. G. You will find
3 x 40 watt type B-10 bulbs.
lower cover
fig. G
Step 4: Loosen and remove burnout bulb(s) and replace with new bulb(s).
Step 5: Replace the lower cover and re-attach all the 11 screws.
Step 6: Replace the rock bed.
Step 7: Hold the front cover tightly and engage it with the 4 locking posts on both sides
of the fireplace. Make sure the front cover has been completely put into ALL 4
locking posts before release your hands.
Step 8: Plug in the unit.
