5
O/I:
Press this button for main power function and flame effect. See below for other
control switches.
1250W:
For heat function – press this switch while the O/I switch is in the ON position.
The indicator light will turn on.
Temperature Control:
To adjust the temperature to your individual requirements, turn
the temperature control dial to the right (clockwise) to increase the desired temperature
and to the left for lower temperature. This temperature control dial can only be used
while the O/I switch and 1250W switch are in the ON position. When the heater reaches
the desired temperature, the heater and 1250W switch indicator light will turn off but
the fan will continue to operate. Adjust this knob to restart the heater.
NOTE:
When the O/I switch is turned off, all other heater functions will stop even though
the switches may be in the on position.
NOTE:
In order to shut down the heater safely, it is recommended to turn the
temperature control knob to lowest setting and allow the heater to cool down before
press the O/I switch to off position.
MAiNtENANcE
wARNINg: disconnect power and unplug the power cord before attempting
any maintenance or cleaning to reduce the risk of fire, electric shock or
damage to persons. The bulbs in your unit can become extremely hot. Allow
at least 10 minutes between turning off the unit and removing the light bulbs
to avoid the accidental burning of the skin.
RIsk OF FIRe: dO NOT exCeed The ReCOMMeNded bulb wATTAge.
rEPlAciNG tHE liGHt BUlBS
Step 1: Remove 12 screws on the back of fireplace and open the rear cover.
Step 2: You will find 1x40W type B-10 bulbs under the log-set bed.
Step 3: Loosen and remove the burnt out bulb and replace with new bulb.
Step 4: Close the rear cover. Secure the 2 larger screws into the top left corner hole
and bottom right corner holes as shown in the diagram. Secure the 10 smaller
screws into the remaining holes. Make sure the screws are in the correct holes
and have been tightened.
Step 5: Plug in the unit.
rEPAir SEt
tOUcH-UP rEPAir PAiNt
Paint directly on the mantel unit if necessary.
rEPAirS
If any problems are found with the original parts during mantel assembly, such as the
panels cannot be installed with the plastic connector, try to solve by one of the following
methods:
Tools required:
Electric drill, drill bits 3/4 inches (10 mm) or 1/16 inches (2 mm), pencil,
hammer, Phillips screwdriver, safety goggles and gloves (if necessary).
wARNINg: wear goggles before you start drilling.
OPTION 1:
Use the spare KD nuts, KD screws and plastic connector.
1. Place the plastic connector on the mantel unit and mark the drill-holes as shown in
Fig. A.
Fig. A
